What are the common troubleshooting methods for high-pressure cleaners

A high-pressure cleaner is a machine that uses a power unit to generate high-pressure water from a high-pressure piston pump to wash the surface. It can remove dirt and wash away to achieve the purpose of cleaning the surface of the object. This cleaning method has no special requirements on the material, characteristics, shape and type of dirt of the equipment. It only needs to be sprayed directly, so it is very widely used. Because it uses high-pressure water jets to clean dirt, high-pressure cleaners are also considered to be one of the scientific, economic and environmental cleaning methods. It can be divided into cold water pressure washer, hot water pressure washer, motor driven high pressure washer, gasoline engine driven high pressure washer.

The high-pressure cleaner is operated by a high-pressure spray method, so the entire cleaning process is very thorough, and it can also meet our needs during use.

There may be some failures during the use of the high-pressure washer. Today, we will talk about one of the solutions to the failure, the treatment method after the pressure gauge of the high-pressure washer is filled with water.

1. The pressure of the high-pressure cleaner is unstable or sometimes no after starting

2. Air is sucked in the high-pressure water pump or the water inlet pipe. At this time, we only need to intermittently trigger the high-pressure water gun, reduce the working pressure of the high-pressure cleaner and run it for a while, until a stable pressure is generated.

3. Insufficient water supply, first check whether the water level of the water tank is too low, whether the water inlet pipe has leaked out of the water and whether the water inlet pipe is leaking. At this time, you need to add water to the water tank or replace with a new water inlet pipe; if it is a non-self-priming pump, you must Check whether the pressure of the water source is sufficient and whether the inlet water flow meets the requirements of the pump.

4. The water inlet filter is clogged, so just clean the water inlet filter at this time.


Website: High Pressure Washers Manufacturer
Email: uicleanmachine@gmail.com
Whatsapp:+86 18638135001
Phone:+86 18638135001
Link: Sitemap